StratoLaunch IV Water Rocket Launcher

The Starter Set contains one StratoLauncher™ IV soda bottle water rocket launcher will enable you to propel a 2-liter plastic (PET) soda pop bottle over 350 feet into the sky using only water and compressed air from a bicycle pump or an air compressor. Completely redesigned in order to prevent air leakage. Heavy duty and great for classrooms!

Hyperloc 163

The HyperLoc is promoted as a "Park Flyer." The designers thought that since it is heavy and robust, it could withstand some faster-than-normal descent speeds and therefore could be used in smaller fields. This is true, but where this kit is a lot of fun is stuffing higher thrust motors into the backend. This rocket is designed for motors that have a brutal kick. It's built for speed!

Black Brant X

The LOC Black Brant X is a pseudo-scale model loosely based on the Candian Sounding Rocket. It's a great all-around flyer that can use a variety of different rocket engines. It's a proven performer that will get the respect of everyone that sees it. This model is going to be your rock-solid favorite that can be flown at any time.

Spek Rocket Kit

The Spek is a two-stage rocket designed specifically for the National Association of Rocketry’s contest for the “Altimeter Altitude” event. In the single-stage configuration, it can use a 13mm diameter 1/4A, 1/2A, or A-size rocket motor. When adding the booster stage, you can use it in the “B-altitude” event, because two A-size engines added together is equivalent to the power of a “B” rocket motor. If you're a rocket competitor, this little bug will get you to the winner's podium.

TARC Success Pack

This is the success package of the most commonly used parts for the 2017-2018 TARC Competition. This pack of parts is a great way to get your designs "off the ground". It contains the most commonly requested components to build rockets for the TARC competition. There are enough material supplies in the package to assemble two rockets. Now you can test different configurations to create your winning rocket!

Altimeter Pouch

Providing extra protection from the soot and the hot gases of the ejection charge, this vinyl protective pouch was designed for the Jolly Logic series of altimeters (AltimeterOne, AltimerTwo, and AltimeterThree). The pouch from Dino Chutes securely holds the altimeter inside during use and keeps it clean, plus it gives a little extra protection from bumps and bruises of the flight.

Chute Release Protector Sleave

This nifty little pouch for the Chute Release (not included) gives you extra peace of mind by protecting your Chute Release from those hot stray ejection charges that might get past your main chute protection. It's also useful once your rocket lands on the ground and gets dragged by the wind. Created by Dino Chutes, it is constructed from Nomex fabric with a hook and loop closure strap that goes under the tether strap. Bright yellow color, so it adds more visibility to your rocket too.

Guide Chute for Chute Release

Designed Dino Chutes to work with the Jolly Logic Chute Release device (not included). This special guide chute is intended to be deployed during the time your rocket is descending from apogee. It basically helps your rocket descend a little slower and also keeps it from drifting too far. Think of it as a funny looking parachute because it has the DNA of a streamer.

Dino Chutes Parachutes

Apogee Components is proud to begin offering Dino Chute X-Form parachutes! X-form parachutes tend to provide a more stable descent as compared to the typical hexagon parachutes. They can also twist a little bit upon descent, so a swivel type attachment is recommended for the larger sizes. An X-form parachute also tends to pack more tightly than a comparable hexagon shaped parachute because there's less fabric overall.